Set Drill Cover Height; Set Substrate Valve - Javo Plus User Manual

5.14 Set drill cover height

Set the height of the drill cover before you start working with
the machine.
The protective cover of the drill must be adjusted to the height of the
pot. Adjust the height of the protective cover such that there is a space
in between the top of the pot and the bottom of the protective cap of
about 4 mm.
Procedure:
1. Open drill cover (A) using the door key.
2. Loosen clamp (B) and adjust the drill cover height with swivel (C). The protective
cover of the drill is important for the safety of the machine operator.

5.15 Set substrate valve

Set the substrate valve before you start working with the machine.
Substrate is rolled from the elevator to the substrate valve. The purpose of
the valve is to control the substrate into the direction of the pots.
Procedure:
1. Loosen clamp (A).
2. Set the substrate valve.
a. Substrate valve can be pushed forwards and backwards.
3. Tighten clamp (A).
4. Set the spout thickness.
a. Loosen clamp (B).
b. Set the spout thickness.
5. Under the valve are placed two wing nuts (C). Turn the wing nuts loose,
adjust the width of the outlet and tighten wing nuts (C) again.
Version 2015-1
User Manual Javo Plus en Plus Extra Potmachine
A
B
C
17