HADEF 53/07 Installation, Operating And Maintenance Instructions page 7

Safety
Supporting structures and load-attached devices used in conjunction with this equipment must provide an
adequate safety factor to handle the rated load plus the weight of the equipment. In case of doubt, consult
a structural engineer.
If the equipment has not been used for a period of time, carry out visual checks of all main components
such as chains, load hooks etc. and replace any damaged parts with new, original spare parts before
putting the equipment back into operation!
Check brakes daily before commencing work!
The load chain must not be twisted.
Twisted chains must be aligned before attaching the load.
The correct alignment of the chain links can be seen from the weld seams.
The chain links must always be aligned in one direction.
Please pay attention to the regulations for load carrying devices UVV BGR500 for both positive and non-
positive methods of attaching loads.
Do not use a hoist that is defective, pay attention to any abnormal noise it makes during operation.
Any damage and faults must be reported to a responsible supervisor immediately.
If the unit is put into motion, any persons in the immediate vicinity must be informed by calling to them!
The lifting tackle or the load must be securely attached to the hook and be seated at the bottom of the
hook.
The safety catch of the hook must be closed.
Stop lowering the load when the bottom block or the load is being set down or is prevented from being
lowered further.
When charged, the housing may not be in contact somewhere.
Pos: 7.2.2.2 /---ALLGEMEIN/Hinweise/WARNUNG - Manipul.Überlast, verschlissene Ketten, beschädgte Haken, (H-ratsch) @ 0\mod_1176815955976_52.doc @ 4845 @ @ 1
WARNING!
The following is not allowed:
to lift another load than the nominal safe working load
to manipulate the sliding clutch
The use of elongated or damaged chains. Replace worn out chains immediately by new,
original chains.
Never loop the load chain around a load nor place or pull the chain over edges.
Never repair damaged load hooks (e.g. by hammering). They must be replaced by original
hooks.
Do not operate the hoist by stepping on the lever with a foot.
Never use an elongation piece for the lever.
It is prohibited to charge the load hook at its point.
It is prohibited to weld or cut when a load is suspended.
It is prohibited to swing the load.
It is prohibited to use the load chain for earthing during welding.
Do not use the hoist when it makes abnormal noise.
Do not use the lever without rubber handle.
Do not leave a lifted load unintended for a longer period of time.
Pos: 8.1 /3--TRANPORT/LAGERUNG/*Ü1*/#. Kapitel - Transport und Lagerung @ 0\mod_1172058584305_52.doc @ 190 @ @ 1
5.52.187.00.01.02
7