Instrument Operation; Multifunction Information Center; Analog Speedometer/Tachometer - Yamaha FX SHO WaveRunner 2013 Owner's/Operator's Manual

Instrument operation

EJU42240
Multifunction information
center
The multifunction information center displays
various watercraft information.
1
1 Information display

2 Analog speedometer/tachometer

3 Multifunction display (FX Cruiser SHO)
1
2
1 "SPEED/RPM" button
2 "VOLT/HOUR" button
3 "START/STOP" button (FX Cruiser SHO)
4 "MODE/RESET" button (FX Cruiser SHO)
Multifunction information center initial op-
eration
When the multifunction information center is
activated, the analog speedometer/tachome-
ter makes one sweep, and all of the display
segments and indicator lights come on. After
2 seconds, the "WARNING" indicator light and
the warning indicators in the information dis-
play go off, and then the center starts to oper-
ate normally.
40
2 3
3
4
TIP:
The "UNLOCK" indicator light will go off when
the engine is started.
Multifunction information center standby
state
If the multifunction information center does
not receive any operation input within 25 sec-
onds after the engine stops, the center will
turn off and enter a standby state. When the
engine is started again, the displays return to
their state before the center turned off, and
then the center starts to operate normally.
EJU42330
Analog speedometer/tachometer
The analog speedometer/tachometer has
both a speedometer function and a tachome-
ter function. By switching the meter, it can be
used as either a speedometer or a tachome-
ter.
TIP:
The analog tachometer is selected at the
Yamaha factory.
Analog tachometer
The analog tachometer shows the engine
speed.
The large outer numbers on the meter show
the engine speed × 100 rpm (r/min).
The "RPM" indicator light comes on when the
analog tachometer is selected.