SCORPOWER Box Functions
POWER Switch and LED
The power ON/OFF switch is located at the back of the power box.
The green POWER LED lights up when the power switch is on. It indicates that
110/220VAC power is being supplied to the power box.
MOTORS LED
The green MOTORS LED indicates whether or not power is being supplied to all
connected motors.
This LED lights up whenever the power box receives a CON (control on) command.
This LED shuts off whenever any of the following occurs:
•
The power box receives a COFF (control off) command.
•
The EMERGENCY button is pressed.
•
The power box detects a communication time-out, and shut itself down.
•
The power box detects an overcurrent error.
Peripheral Axes: AXIS 7 and AXIS 8
The D9 connectors on the front panel of the SCORPOWER box, marked AXIS 7 and
AXIS 8, permit motorized devices to be connected to and controlled by Controller-PC.
Turn off both the power box and the PC before you connect any device.
The following SCORBOT motorized accessories can be orderd and used with
Controller-PC.
•
48" Linear Slidebase, 24V ______________ Catalog #1001
•
1.0m Linear Slidebase, belt-drive, 24V ____ Catalog #1018
•
1.0m Linear Slidebases, screw-drive, 24V __ Catalog #1008
•
1.5m Linear Slidebases, screw-drive, 24V __ Catalog #1007
•
Conveyor Belt (orange), 12V ____________ Catalog #1003
•
Conveyor Belt (gray), 12V ______________ Catalog #1006 (discontinued)
User's Manual
9709
4
CHAPTER
13
Controller-PC