Communication Connections - Barco HDX 4K User Manual

5.3

Communication connections

Communication Panel
1 2 3
Image 5-4
Optional feature for future expansion
1
2 12V 1A output
USB backup custom settings
3
4
10/100 base-T for external control over IP and Art-Net
5 Feature for future expansion
6 Feature for future expansion
7 XLR input for wired projector control
12V output
12 V output, maximum 1A, available when projector is not in stand by.
DMX interface
DMX is used as communication bus between different devices in the light technic. Each device has an input and an output, so that
the bus can be looped between the different devices. According the standard a five wire cable with XLR connector is used.
You can use the DMX input port to connect a DMX device (DMX console) to the projector. This way you can control the projector
from that DMX device (console). The DMX output port can be connected with the next device in the loop.
Pin
1
2
3
4
5
DMX
DMX-512 Lighting protocol over RS-485 interface. Carries information of 512 channels from a lighting controller to
lighting devices. Standardized by USITT.
RS232/RS422 input
The communication interface of the HDX supports RS232 and RS422 serial communication on two different types of input connec-
tors. The left one a Sub-D connector, the right one an USBB connector acting as RS input when connected to an USB input of a PC.
You can use the RS232/RS422 input to connect a local PC to your HDX. By this way you can configure and control your HDX from
your local PC.
Advantages of using RS232/RS422 serial communication:
R5906070 HDX 4K 23/09/2016
4 5
Description
Earth
Cold
Hot
Return - (or not used)
Return + (or not used)
6 7
8
RS232 for serial communication
9 Sync Out
Sync In
10
11 Status lights
12
IR receive sensor
13 Optional feature for future expansion
5. Input & Communication
8 9 10 11 12 13
43