Figure 4-3 Us Nim Build Type Select Menu; Table 4-3 Ucn Node Configuration - Honeywell FSC-SM Installation Manual

4.3 Configuration at TPS Universal Station,
NIM Build Type Select
Menu display
Figure 4-3 – US NIM Build Type Select Menu
MENU
NIM BUILD TYPE SELECT MENU
F1=PED
F2=RECALL DISP
UCN Node
Configuration display
10/01
The NIM Build Type Select Menu display will be the next display to come
up. This display is shown in Figure 4-3. Select the UCN NODE
CONFIGURATION target to configure the UCN.
F3= F5=OVERWRITE
F4= F6=
You should now be in the UCN Node Configuration display. Figure 4-4
shows this display. Do the steps in Table 4-3 to configure the UCN.
Table 4-3 – UCN node configuration
Step
1 Enter the requested data in the given slots. All configuration
information should be taken from the FSC-SM Configuration Forms
you have filled out.
Select the FSC-SM for UCN node type and FSC for the FSC-SM
2
platform.
3 Press the [F12 LOAD] key to load your configuration.
The node number you select must correspond with the
ATTENTION
node number you entered for the UCN configuration at the FSC user
station.
FSC Safety Manager Installation Guide
UCN
NODE
CONFIGURATION
NODE
SPECIFIC
CONFIGURATION
PROCESS
POINT
BUILDING
LIBRARY
CONFIGURATION
F7=RECON F9 =WLK BACK
F8=PED STATUS F10=WRITE
Action
Continued
11 Jun 97 14:05:00 3
PAGE 01 OF 01
F11=
F12=LOAD
Continued on next page
53