Table of Contents
Advertisement
Section 1 – FSC Safety Manager System Installation
1.1
Section Overview
About this section
Subsection
1.1
1.2
1.3
1.4
Tools and test
equipment
10/01
This section provides general installation information for the FSC Safety
Manager (FSC-SM) system. Topics included in this section are:
Section Overview ........................................................................................ 1
Equipment Warehousing ............................................................................ 2
Move Preparation........................................................................................ 3
Unpacking and Placement........................................................................ 13
The following equipment is necessary for installation of the FSC Safety
Manager:
• Mobile lifter/lift truck — refer to Subsection 1.4 (Unpacking and
Placement),
• Carrier band MAP tester — refer to Subsection 2.2 (Installation
Considerations),
• Hand tools and multimeter, as in a typical electrician's tool kit,
• UCN Connector Torque Wrench Kit (part number: 4605459),
• Set of SAE (inch) "crow's foot" wrenches for the above torque wrench,
• ESD kit (Honeywell part number 30185-H).
Installation of the FSC Safety Manager may only be
ATTENTION
carried out by qualified and authorized personnel. Failure to comply with
the regulations and recommendations contained in this document may
cause severe damage to the equipment or serious injury to people.
REFERENCE — For detailed information regarding
• site planning and installation, refer to SM02-550 TPS System Site
Planning Manual in Binder TPS 3020-1 System Site Planning-1.
• post-installation checkout procedures, refer to the FSC Safety Manager
Service Manual in this binder.
FSC Safety Manager Installation Guide
Topic
See Page
1
Hide quick links:
Advertisement
Table of Contents
