Procedure For The Measurement - Nissei WS-1011 Instruction Manual

PROCEDURE FOR THE MEASUREMENT

IMPORTANT! The device has sensor keys and clicking is a slight touch of a fi nger.
Moisture, dirt and other objects between the fi nger and panel of the device can aff ect the ability to respond to the touching keys.
Before measuring make 5-6 deep breaths and relax.
Do not move, talk, and do not strain your arm during the measurement.
1. Touch "START/STOP". Air is exhausted from the cuff (fi g.8).
2. Automatic infl ation starts. Infl ation stops when the pressure, that is, the displayed value, reaches the designated value.
3. Pressure starts to decrease.
Body Motion Symbol
Blood pressure value taken while moving cannot be said to be the correct value because body movement can aff ect blood pressure. This
product analyzes pulse wave and displays «
Touch "START/STOP" again to cancel measurement. The monitor will exhaust air from the cuff and turn off .
4. Pulse Symbol «» is displayed as pulse is detected (fi g.10).
5. Air is released from the cuff and measured values are displayed as measurement completes (fi g.11).
6. Touching or will switch the bank.
7. Touch "START/STOP" .
The monitor will be turned off . Even if you do not turn off the monitor, it turns off automatically after 3 minutes.
Do not execute repeated measurements for congestion of blood could result in false measurement.
Let your wrist rest for at least 5 minutes.
» when body motion is detected. «
60
» indicates the results might be aff ected by body movement.
Fig.8
Fig.9
Fig.10
Fig.11