Table of Contents
Advertisement
Fig.8
Fig.9
Fig.10
MEASUREMENT PROCEDURE
1. Insert the Air Plug into the Air connector (fi g.11).
Do not move, do not speak and do not toughen your arm.
2. Press «
» button. The screen will, for a short time, display all
the characters. Then, the result of the previous measurement will ap-
pear on the screen, the release symbol will fl ash, and the device will
release the remaining air from the cuff (fi g. 12).
If the measurement is taken after installing the batteries, only the re-
lease symbol « » appears.
3. Rapid air injection into the cuff will start. At this, the « » symbol will
fl ash and the value displayed will be increasing (fi g. 13).
4. The « » symbol will disappear, and the measurement will start. Dur-
ing this, the pressure in the cuff will slowly be increasing.
3 Fix the cuff so that it fi ts tightly to the arm, but see that it is not over-
tight (fi g. 8). Too tight or too free placement of the cuff may give inaccurate
readings.
4 If the arm is cone-shaped, it is recommended to put the cuff spirally, as
shown in the fi gure (fi g.9).
5 If the rolled-up sleeve squeezes the arm interfering with free blood fl ow
the Device may give inaccurate fi gures not corresponding to your actual
blood pressure (fi g.10).
8
Fig.11
Fig.12
Advertisement
Table of Contents
