Beab Care Requirements - Mira Advance ATL Thermostatic Installation & User Manual

The installation should be carried out by an electrician or contractor who is
registered, or is a member of, an association such as:
• Part P. (Building Regulations.)
• NICEIC approved domestic installer.
• The Electrical Contractors Association, England and Wales. (ECA.)
• The Electrical Contractors Association of Scotland. (SELECT.)
2.4 The plumbing installation must comply with the requirements of UK Water
regulations/bye-laws (Scotland), building regulations or any particular
regulations and practices, specified by the local water company or water
undertakers. The installation should be carried out by a plumber or contractor
who is registered, or is a member of, an association such as:
• Institute of Plumbing and Heating Engineering, throughout the UK.
(Iphe.)
• Association of Plumbing and Heating Contractors, England and Wales.
(aphc.)
• Scottish and Northern Ireland Plumbing Employers' Federation, Scotland
and northern Ireland. (SnIpeF.)
2.5 Anyone who may have difficulty understanding or operating the controls of
any shower should be attended whilst showering. particular consideration
should be given to the young, the elderly, the infirm or anyone inexperienced
in the correct operation of the controls. children must be supervised to make
sure that they do not play with the appliance.
2.6 When this appliance has reached the end of its serviceable life, it should
be disposed of in a safe manner, in accordance with current local authority
recycling, or waste disposal policy.

BeAB CARe Requirements:

routine maintenance is required for all beab care installations. The Inlet Filter shall
be cleaned or replaced after the first 6 months of use. This shall then be repeated
every 12 months. refer to section: "Maintenance", on how to safely remove the
Filter.
Year
1
2
3
4
5
6
7
8
9
10
6 Monthly Signature 12 Monthly
5
Signature