Fault Diagnosis; User Troubleshooting Guide - Mira Advance ATL Thermostatic Installation & User Manual

1. user Troubleshooting Guide

The Mira advance aTL electric shower is fully performance tested after assembly. In
the unlikely event that you experience problems with the appliance, then the following
procedures will enable you to undertake basic troubleshooting before contacting the
competent tradesperson responsible for installing your shower.
Warning! There are no user serviceable components beneath the cover of the
appliance.
only a competent tradesperson should remove the cover whilst observing the
warnings given in section "2. Installer Troubleshooting Guide" prior to performing
any maintenance.
Water supply Light
The Water supply is a warning light that will flash or be lit solid together with a
beeping tone in the event of:
• Incoming water temperature is too high.
• Incoming water pressure is too low.
Showering performance will be reduced until the supply is restored to the required
conditions. refer to "Specifications". once the supply is restored, the Water supply
light will go out. For the most likely causes of reduced shower performance, refer to
"shower Performance" and "operation".
If the warning continues, contact a competent tradesperson who can further
investigate the cause.
Reset Light
The shower automatically stops and the Reset light will flash or be lit solid together
with a beeping tone in the event of:
• Appliance failure
• Supply conditions that may cause unsafe showering.
other indicator lights will vary depending upon the fault. If any other fault condition
occurs that is not listed in this guide, contact the installer or Mira customer Service
dept.

FAuLT DIAGnosIs

21