Important Safety Information - Mira Advance ATL Thermostatic Installation & User Manual

IMPoRTAnT sAFeTy InFoRMATIon

1. Warning!
1.1 products manufactured by us are safe and without risk provided they are
installed, used and maintained in good working order in accordance with our
instructions and recommendations.
1.2 ThIs APPLIAnCe MusT Be eARTheD. Make sure any supplementary
bonding complies with the "requirements for electrical installations" and is in
accordance with Bs 7671.
1.3 Do noT twist the individual cable cores of the live and neutral conductors, as
this will prevent them from entering the terminal block.
1.4 The shower unit must not be fitted where it may be exposed to freezing
conditions. Make sure that any pipework that could become frozen is properly
insulated. If the appliance appears to be frozen, allow to thaw and then
contact your installer before using again.
Do noT switch on the appliance if there is a possibility that the water in the
heater is frozen.
1.5 Do noT operate this appliance if water leaks from the case. Maintenance
may be required before the appliance can be safely used.
1.6 Do noT fit any form of outlet flow control as the outlet acts as a vent for the
tank body. Only Mira recommended outlet fittings should be used.
1.7 There are no user serviceable components beneath the cover of this
appliance. only a competent tradesperson should remove the cover and only
genuine Mira replacement parts are to be used.
1.8 If any of the following conditions occur, isolate the electricity and water
supplies. contact your installer or refer to 'To contact us', on the back page of
this guide:
If the cover is not correctly fitted and water has entered the case.
1.8.1
1.8.2 If the case is damaged.
1.8.3 If the appliance begins to make an odd noise, smell or smoke.
1.8.4 If the appliance shows signs of a distinct change in performance,
indicating a need for maintenance.
1.9 refer to the wiring diagram before checking any electrical connections.
1.10 Make sure all electrical connections are tight, to prevent arching or
overheating.
2. Caution!
2.1 read all of these instructions and retain this guide for later use.
2.2 Follow all warnings, cautions and instructions contained in this guide, and on
or inside the appliance.
2.3 The electrical installation must comply with the "requirements for electrical
Installations" commonly referred to as the Iee Wiring regulations, or any
particular regulations and practices, specified by the local electricity supply
company in force at the time of installation.
4