Frymaster LOV BIGL30 Series Installation, Operation And Maintenance Manual page 24

1. Fill the frypot with cooking oil to the bottom OIL LEVEL line located on the rear of the frypot.
This will allow for oil expansion as heat is applied. Do not fill cold oil any higher than the bot-
tom line; overflow may occur as heat expands the oil.
2. Ensure that the power cord(s) are plugged into the appropriate receptacle(s). Verify that the face
of the plug is flush with the outlet plate, with no portion of the prongs visible.
3. Ensure that the oil level is at the top OIL LEVEL line when the oil is at its cooking temperature.
It may be necessary to add oil to bring the level up to the proper mark, after it has reached cook-
ing temperature.
3.2.2 Lighting the Fryer
1. Press the controller ON/OFF switch to the OFF position.
2. Press the controller ON/OFF switch to the ON position and program the controller for normal
cooking temperature.
3. If the burners fail to light, press the ON/OFF switch to the OFF position and wait 60 seconds.
Repeat step 2.
The fryer will automatically enter the melt cycle mode if the frypot temperature is below 180ºF
4.
(82ºC). (NOTE: During the melt cycle, the burners will repeatedly fire for a few seconds, then
go out for a longer period.) When the frypot temperature reaches 180ºF (82ºC), the unit will au-
tomatically switch to the heating mode. The burners will remain lit until the frypot temperature
reaches the programmed cooking temperature. Once the fryer reaches setpoint, the controller
display changes to ---- or product name and the fryer is ready for use.
and hold the X button during melt cycle. The controller displays EXIT MELT? YES/NO. Press the but-
ton associated with YES to EXIT MELT?
5. After the burners have been lit for at least 90 seconds, observe the flames through the burner
viewing ports located on each side of the combustion air blower.
3-3
To exit the melt cycle, press