Configuring An Nqa Test Group; Configuring An Icmp Echo Test - H3C S5820X Series Configuration Manual

To do...
Enter system view
Create an NQA test group and
enter the NQA test group view
If you execute the nqa entry command to enter the test group view with test type configured, you
directly enter the test type view of the test group.

Configuring an NQA Test Group

Configuring an ICMP Echo Test

An ICMP echo test is used to test reachability of the destination host according to the ICMP echo reply
or timeout information. An ICMP echo test has the same function as the ping command but provides
more output information. It enables you to locate connectivity problems in a network.
Follow these steps to configure an ICMP echo test:
To do...
Enter system view
Enter NQA test group view
Configure the test type as ICMP
echo and enter test type view
Configure the destination address
for a test operation
Configure the size of probe
packets sent
Configure the filler string of a
probe packet sent
Specify a VPN instance
Use the command...
system-view
nqa entry admin-name
operation-tag
Use the command...
system-view
nqa entry admin-name
operation-tag
type icmp-echo
destination ip ip-address
data-size size
data-fill string
vpn-instance instance
2-6
Remarks
—
Required
Remarks
—
—
Required
Required
By default, no destination IP
address is configured for a test
operation.
Optional
100 bytes by default.
Optional
By default, the filler string of a
probe packet is the hexadecimal
number 00010203040506070809.
Optional
Not specified by default.