Configuring The Collaboration Function - H3C S5820X Series Configuration Manual

To do...
Configure common optional
parameters

Configuring the Collaboration Function

Collaboration is implemented by establishing reaction entries to monitor the detection results of the
current test group. If the number of consecutive probe failures reaches the threshold, the configured
action is triggered.
Follow these steps to configure the collaboration function:
To do...
Enter system view
Enter NQA test group view
Enter test type view of the test
group
Configure a reaction entry
Exit to system view
Configure a track entry and
associate it with the specified
reaction entry of the NQA test
group
You cannot modify the content of a reaction entry by using the reaction command after the
reaction entry is created.
The collaboration function is not supported in a UDP jitter test.
Use the command...
See Configuring Optional
Parameters Common to an NQA
Test Group
Use the command...
system-view
nqa entry admin-name
operation-tag
type { dhcp | dlsw | dns | ftp | http
| icmp-echo | snmp | tcp |
udp-echo }
reaction item-num
checked-element probe-fail
threshold-type consecutive
occurrences [ action-type { none |
trigger-only } ]
quit
track entry-number nqa entry
admin-name operation-tag reaction
item-num
2-19
Remarks
Optional
Remarks
—
—
The collaboration function is not
supported in UDP jitter tests.
Required
Not created by default.
—
Required
Not created by default.