Scheduling An Nqa Test Group - H3C S5820X Series Configuration Manual

To do...
Configure the interval between two
consecutive tests for a test group
Configure the number of probes in
an NQA test
Configure the NQA probe timeout
time
Configure the maximum number of
hops a probe packet traverses in
the network
Configure the ToS field in an IP
packet header in an NQA probe
packet
Enable the routing table bypass
function

Scheduling an NQA Test Group

By configuring NQA test group scheduling, you can set the start time and test duration for a test group
to perform NQA tests. The start time can take a specific value or can be now, which indicates that a
test is started immediately; the test duration can take a specific value or can be forever, which
indicates that a test does not stop until you use the undo nqa schedule command to stop the test.
Use the command...
frequency interval
probe count times
probe timeout timeout
ttl value
tos value
route-option bypass-route
2-23
Remarks
Optional
By default, the interval between
two consecutive tests for a test
group is 0 milliseconds, that is,
only one test is performed.
If the last test is not completed
when the interval specified by the
frequency command is reached, a
new test is not started.
Optional
By default, one probe is performed
in a test.
Optional
By default, the timeout time is
3000 milliseconds.
This parameter is not available for
a UDP jitter test.
Optional
20 by default.
This parameter is not available for
a DHCP test.
Optional
0 by default.
This parameter is not available for
a DHCP test.
Optional
Disabled by default.
This parameter is not available for
a DHCP test.