Configuring An Snmp Test - H3C S5820X Series Configuration Manual

To do...
Configure the size of a probe
packet sent
Configure the filler string of a
probe packet sent
Configure the number of packets
sent in a UDP jitter probe
Configure the interval for sending
packets in a UDP jitter probe
Configure the time for waiting for a
response in a UDP jitter test
Configure the source IP address of
a probe request in a test operation
Configure common optional
parameters
The number of probes made in a UDP jitter test depends on the probe count command. The number
of probe packets sent in each probe depends on the configuration of the probe packet-number
command.

Configuring an SNMP Test

An SNMP query test is used to test the time the NQA client takes to send an SNMP query packet to
the SNMP agent and then receive a response packet.
Use the command...
data-size size
data-fill string
probe packet-number
packet-number
probe packet-interval
packet-interval
probe packet-timeout
packet-timeout
source ip ip-address
See Configuring Optional
Parameters Common to an NQA
Test Group
2-14
Remarks
Optional
100 bytes by default.
Optional
By default, the filler string of a
probe packet is the hexadecimal
number 00010203040506070809.
Optional
10 by default.
Optional
20 milliseconds by default.
Optional
3000 milliseconds by default.
Optional
By default, no source IP address is
specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
Optional