Ping And Tracert Configuration Example - H3C S5820X Series Configuration Manual

To do...
Enable debugging for a specified
module
Display the enabled debugging
functions
To display the detailed debugging information on the terminal, configure the debugging, terminal
debugging and terminal monitor commands. For more information about the terminal debugging
and terminal monitor commands, see Information Center Configuration Commands in the Network
Management and Monitoring Command Reference.

Ping and Tracert Configuration Example

Network requirements
As shown in Figure
Device A and Device C can reach each other. If they cannot reach each other, locate the failed
nodes in the network.
Figure 1-4 Ping and tracert network diagram
Configuration procedure
# Use the ping command to display whether Device A and Device C can reach each other.
<DeviceA> ping 1.1.2.2
PING 1.1.2.2: 56 data bytes, press CTRL_C to break
Request time out
Request time out
Request time out
Request time out
Request time out
--- 1.1.2.2 ping statistics ---
5 packet(s) transmitted
0 packet(s) received
Use the command...
debugging { all [ timeout time ] |
module-name [ option ] }
display debugging [ interface
interface-type interface-number ]
[ module-name ] [ | { begin |
exclude | include }
regular-expression ]
1-4, Device A failed to telnet Device C. It is required to determine whether
1-7
Remarks
Required
Disabled by default
Available in user view
Optional
Available in any view