Unpacking And Installation - EIP CD35 Owner's Manual

The Adjustable Humidistat: The adjustable humidistat enables you to
maintain the required level of dryness within a room. The humidistat switches
off the CD35 when the relative humidity falls to the level predetermined by the
position of the humidistat control.
The Water Tank: When the water tank has reached its capacity, a float
mechanism will activate a microswitch lever and switch off the machine. The
container-full indicator will also illuminate.
Before emptying the water container, disconnect the power supply and allow
the dryer to stand for five minutes. Remove the container from the rear of the
unit and when emptied, replace, taking care to ensure that the float
mechanism is correctly positioned. Restart unit as instructed in the following
Operation section of this manual.
After removing the CD35 from its shipping container, visually check for signs
of damage. If there is evidence of damage, do not operate. Call your supplier
for advice. Do not discard the packing as it will be useful when transporting
the machine in the future.
Wiring: Connect the power cord to a grounded single phase, 15 Amp fused,
standard household wall socket.
Single Room: Position the CD35 in the center of the room to be dried.
However, if a damp patch is particularly apparent, the outlet grille should be
directed towards it. If the CD35 cannot be positioned centrally, a minimum
space of 6" should be allowed around the dryer.
Several Rooms: To dry a number of rooms simultaneously with the most
efficiency, the dryer as to be positioned between the rooms. Ensure that all
doors are left ajar allowing a patch for the air to circulate to the unit. An
auxiliary circulation fan would be helpful.
FEATURES
UNPACKING & INSTALLATION
POSITIONING
Page 4 of 12
Drawing : - TPC225
Issue : - 3
Date : - 05/01/12