Page 1
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 DUAL VOLTAGE RM85-H INDUSTRIAL DEHUMIDIFIER OWNER’S MANUAL www.eipl.co.uk Page 1 of 16...
Page 2
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 INTRODUCTION Designed for a wide range of applications, the RM85H is a rugged, industrial unit, which utilizes an energy-efficient compressor and a compact portable design to provide easy efficient drying. The RM85 has a number of special features: •...
Page 3
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 Remove the lower screw and swing the cover to one side to reveal the access hole. The switch lever can be seen through the hole. Using a flat blade screwdriver move the switch lever down to the 230 volt position.
Page 4
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 BACK SHELL REMOVAL To remove the back shell and access the voltage selection switch please carry out the following steps. • Locate 2 off cap headed bolts on back of unit and remove •...
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 OPERATION The following procedures should be followed to test the RM85 for correct operation: After unpacking, examine all external features to confirm damage- free shipment. Report all defects and damage at once. Ensure the correct voltage has been selected.
Page 7
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 When the unit is operated in ambient of less than 15° C, a defrost cycle should occur approximately every hour. The exact time is impossible to predict as the unit is fitted with a temperature sensitive defrost control.
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 ROUTINE SERVICE WARNING: ENSURE THAT THE POWER CORD TO THE MACHINE HAS BEEN DISCONNECTED BEFORE CARRYING OUT ROUTINE SERVICE. THE SERVICING AND REPAIR OF THIS UNIT SHOULD ONLY BE CARRIED OUT BY A SUITABLY QUALIFIED PERSON.
Page 9
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 REPAIRS Should an electrical component fail, consult the Factory Service Center to obtain the proper replacement part. If refrigerant gas is lost from the machine, it will be necessary to use a refrigeration technician to correct the fault.
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 TROUBLESHOOTING YMPTOM AUSE EMEDY 1. Check the power from 1. No power to unit power supply panel. Unit inoperative 2. Mains cable damaged. 2. Contact the Factory Service Center 1.
Page 12
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 WARNINGS This appliance can be used by children from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the application in a safe way and understand the hazards involved.
Page 13
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 Page 13 of 16...
Page 14
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 Page 14 of 16...
Page 15
Drawing : - TPC442 Issue : - 2 Date : - 24/11/16 Page 15 of 16...