HP XP7 User Manual page 81

SSB2 code Description
230A The pair was not created because the volume you specified as the S-VOL is the P-VOL of the BC Z
pair that has an MU number of 0.
230B The pair task was rejected because the pair is being suspended or deleted.
2310 One of the following occurred:
Pair creation was rejected because the specified CG number had already been used for an L1
pair.
Pair creation was rejected because the specified CG number had already been used for an L2
pair.
Pair creation was rejected because the volume you specified as the P-VOL is the S-VOL of the pair
which is in the process of being Quick Split.
The Quick Restore was rejected because the VLL setting of the P-VOL is different from that of the
S-VOL.
The pair task was rejected because the specified P-VOL and S-VOLs were a Compatible FlashCopy
pair.
The reverse resynchronization was rejected because the pair of the specified P-VOL and S-VOLs
is suspended ("Suspend/SUSPER" status).
The reverse resynchronization was rejected because the specified P-VOL and the S-VOL is the L2
pair.
The CG pair-split was rejected because some of the pairs in the CG were being resynchronized,
split, or were already suspended.
The pair task was rejected because the pair status of the P-VOL, the S-VOL, or both showed that
the pair could not receive the issued command.
2312 The pair task was rejected because the volume you specified as the S-VOL is online to the host.
2314 The pair was not created because the volume you specified as the S-VOL is the S-VOL of another pair
that has been split ("Split/SUSPOP" status).
231F The pair was not restored because the P-VOL of the specified pair is online to the host.
2322 The pair task was rejected because there is not a sufficient amount of installed shared memory or
initialization is not completed.
2324 The pair task was rejected because the number of slots of the volume you specified as the P-VOL
exceeded the upper limit.
2325 The pair task was rejected because the number of slots of the volume you specified as the S-VOL
exceeded the upper limit.
2326 The pair was not created because the volume you specified as the P-VOL had already had three
S-VOLs.
2327 The pair was not created because the node volume specified as the P-VOL had already had two
S-VOLs.
2328 The pair task was rejected because the pair configuration exceeded the number of the layers of the
cascade configuration.
2329 The pair task was rejected because the volume you specified as the S-VOL is the S-VOL of an existing
pair.
232A The pair was not created because pairs that would exceed the license capacity were going to be
created.
232F The pair task was rejected because the volume you specified as the P-VOL is allocated as the destination
of the Auto LUN.
2331 The pair task was rejected because the capacity of the specified P-VOL is not the same as the S-VOL's.
2332 The pair was not created because the volume you specified as the P-VOL had already had three
S-VOLs.
Locating and interpreting error codes and logs using the RAID Manager or BCM 81