Installation And Atp Order; Installation Order; Atp Order - Motorola SC 300 Installation Manual

Installation and ATP Order

Installation Order

ATP Order

JAN 2002
SCt300 1X BTS Hardware Installation, ATP, and FRU Procedures
The pieces of the MicroCell and Primary Surge Suppressor units should
be installed in the following order.
1. Unpack and inspect hardware
2. Install mounting hardware and bracket(s)
3. Install back solar cover to mounting bracket (required for outdoor
installations and optional for indoor applications if fin covers will
not be used).
4. Install RGPS head.
5. Prepare site cabling.
6. Install back fin cover to unit (required for indoor applications if solar
covers will not be used).
7. Attach installation handles to unit (optional).
8. Attach and secure unit to mounting bracket.
9. Remove installation handles (if used).
10. Attach and secure Primary Surge Suppressor to mounting bracket
(optional).
11. Attach all ground cabling to unit(s).
12. Remove Site I/O dust cover.
13. Attach Site I/O junction box to unit.
14. Attach Subscriber Unit (SU) to unit.
15. Attach front fin cover (required for indoor applications if solar
covers will not be used).
16. Install short duration battery (if required).
17. Attach all cables to unit(s).
18. Terminate all unused connections.
19. Attach front solar cover (required for outdoor installations and
optional for indoor applications if fin covers will not be used).
The ATP for the MicroCell unit is performed in the following sequence:
1. BTS preparation
2. Connecting the LMF to the BTS
3. Connecting test equipment to the BTS and LMF
4. Establishing an MMI communications session
5. Setting customer operating channel
6. Synchronization verification
7. Install LMF program and binaries
8. Start LMF and log on to BTS
9. Update BTS–specific CDF file device load version
10. Download and enable MAWI
DRAFT
1
1-27