Installation Tools And Materials; Required Tools And Materials For Installing The Mounting Bracket On A Rack; Required Tools And Materials For Installing The Mounting Bracket On A Concrete Wall - Motorola SC 300 Installation Manual

Installation Tools and Materials

1
Required Tools and Materials
for Installing the Mounting
Bracket on a Rack
Hand Tools
T30 Torx tamper bit, 1/4–in. hex
Torque driver wrench, 1/4–in. hex
female drive, 0–10 N–M
Required Tools and Materials
for Installing the Mounting
Bracket on a Concrete Wall
Hand Tools
T30 Torx tamper bit, 1/4–in hex
15/16-in. (23.8 mm) socket, a ratchet
wrench, and an 18-in. (45.7 cm)
breaker bar
safety glasses
chalk for marking outline on wall
tape measure
4-ft (1.22 m) bubble level
rubber mallet
ear plugs
dust mask
1-12
The following tools and materials in Table 1-2 are required to properly
and safely install the mounting bracket on a rack.
Table 1-2: Required Tools and Materials for Rack Mounting
MicroCell Mounting Kit
Four machine screws 12–24
5/8-in. self tapping (customer
Chalk or marker to mark
The following tools and materials in Table 1-3 are required to properly
and safely install the mounting bracket on a concrete wall.
Table 1-3: Required Tools and Materials for Concrete Wall Mounting
Hilti anchors (for each
MicroCell Mounting Kit
SCt300 1X BTS Hardware Installation, ATP, and FRU Procedures
– continued
Materials
supplied)
location on rack
(customer supplied)
electrical tape
(customer supplied)
Materials
metal shim material
bracket)
electrical tape
(customer supplied)
Power Tools
No Power Tools Required
Power Tools
Hilti wall drilling rig
Hilti DCM 18–14 metric bit
shop vacuum
JAN 2002
DRAFT