Atp Tools And Materials; Test Equipment List - Motorola SC 300 Installation Manual

ATP Tools and Materials

1

Test Equipment List

1-14
– continued
The following pieces of test equipment are required during the ATP.
Common assorted tools like screwdrivers and keys are not listed but are
still required. Read the owners manual on all of the following major
pieces of test equipment to understand their individual operation prior to
use in optimization.
CDMA LMF Hardware Requirements
A CDMA LMF computer platform that meets the following
requirements (or better) is recommended:
S
Notebook computer
S
266 MHz (32 bit CPU) Pentium processor
S
4 Gbyte internal hard disk drive
S
Color display with 1024 x 768 resolution
S
128 MB RAM
S
CD ROM drive
S
3 1/2 inch floppy drive
S
Serial port (COM 1)
S
Serial port (COM 2)
S
Parallel port (LPT 1)
S
PCMCIA Ethernet interface card (for example, 3COM Etherlink III)
with a 10Base–T–to–coax adapter
S
Windows 98 SE
RS232 to GPIB Interface
One National Instruments GPIB–232–CT with Motorola
CGDSEDN04X RS232 serial cable or equivalent; used to interface the
LMF to the test equipment.
A Standard RS–232 cable can be used with the following modifications:
S
Pin 8 (CTS) does not have to be jumpered/shorted to the others as it is
a driver output. The DTR is already a driver output signal. The other
pins are to receivers. Short pins 7, 1, 4, 6 on each cable end:
SCt300 1X BTS Hardware Installation, ATP, and FRU Procedures
NOTE
Always refer to specific OEM test equipment
documentation for detailed operating instructions.
NOTE
If 800 x 600 pixel resolution is used, the CDMA LMF
window must be maximized after it is displayed.
JAN 2002
DRAFT