Lockly Secure User Manual page 20

3.6 Adding a Fingerprint (Continued)
Upon pressing "FP", you will enter Fingerprint Registration Mode and you will see a green
LED ring light up on the fingerprint panel on the exterior side of Lockly™ Secure Plus / Pro.
SECTION 3.6
Once you're in Fingerprint Registration Mode you will see
two numbers displayed on keypad. The top number is your
Fingerprint Registration number, in this example to the left,
"1". The bottom number will always start with a "6".
You must successfully scan your fingerprint six (6) times for it
to properly register. Every time you scan your fingerprint, the
number on the bottom will change, starting from 6 - then 5, 4,
3, 2, 1, until the fingerprint is successfully registered.
Note: For reference, please keep a record of your fingerprint
registration number to distinguish whom it was registered to.
While in Programming Mode,
select "1AD" to add an Access
Code. If you are not in Pro-
gramming Mode, please see
Section 3.2 to enter Program-
ming Mode.
After pressing "1AD" press
"FP" to register a Fingerprint.
17