Briggs & Stratton 1695734 Setup Manual page 3

CHECK OIL LEVEL
Remove oil dipstick (Q, Figure 8). Check oil level. Oil level
should be between FULL and ADD marks. Add oil if required
(See Operator's Manual). Reinstall oil dipstick.
FULL
Q
Figure 8
Check the Tires
Check tires for damage. Check the air pressure in the tires
with an accurate gauge. See the sidewall of the tire for the
proper infl ation.
Avoid Injury! Explosive separation of
WARNING:
tire and rim parts is possible when they are serviced
incorrectly.
• Do not attempt to mount a tire without the proper
equipment and experience to perform the job.
• Do not infl ate the tires above the recommended
pressure.
• Do not weld or heat a wheel and tire assembly. Heat can
cause an increase in air pressure resulting in an
explosion. Welding can structurally weaken or deform
the wheel.
• Do not stand in front or over the tire assembly when
infl ating. Use appropriate tool that allows you to stand
to one side.
NOTICE: Check side of tire for maximum tire pressure.
DO NOT exceed maximum.
Remove Snow Thrower from Pallet
1. Remove straps that secure snow thrower to pallet.
2. Remove snow thrower from pallet.
3. Adjust the skid shoes so that the scraper bar has 1/8-
3/16" clearance above the ground.