Briggs & Stratton 1695734 Setup Manual page 2

Figure 4
NOTE: If the chute rotation is slow or binding, loosen the
chute rotation screws (L, Figure 4) 1/4 turn.
Install the Discharge Chute
NOTE: Some models have the discharge chute already
installed.
1. Place discharge chute (
ring (N) as shown.
2. Secure discharge chute with three carriage bolts (
nuts (P).
M
P
P
Figure 5
3. Tighten hardware to 66 in-lbs (7.6 Nm).
4. Connect the wire harness (electric chute models only).
NOTE: Check all bolts and nuts in fl ange for tightness. Do not
overtighten.
M, Figure 5) over tabs on chute
O) and
O
P
N
Route Defl ector Cable & Clip (if included)
L
Figure 6
Figure 7