Filling The Dishwasher Salt Dispenser; Care And Maintenance - Viking Range 5 SERIES Use & Care Manual

Table of Contents

Advertisement

C
If you move your dishwasher to another house,
it is necessary to readjust water hardness level
of your machine by considering the information
given above according to the hardness level
of the supply water in your new location. Your
machine will display the most recently adjusted
water hardness level.
9. FILLING THE DISHWASHER SALT
DISPENSER
(Select Models)
Water softening system needs to be regenerated in
order for the unit to operate with the same performance
continuously. Dishwasher salt is used for this purpose.
C
Use only special softening salts produced
particularly for the dishwashers in your
machine.
C
It is recommended to use granule or powder
softening salts in the water softening system.
Do not use salts that do not completely
dissolve in water such as table salt or rock
salt. Otherwise the performance of the
system may deteriorate in time.
C
Salt reservoir will be filled with water when
you start the product. For this reason, add
salt before operating the machine.
1. Take the lower basket out to add softening salt.
2. Turn the salt reservoir lid counter-clockwise to open it
(A, B).
3. Add 4 cups of water to salt reservoir of your machine
only in initial use (C).
4. Fill the salt reservoir with salt by using the salt funnel
(D). To speed up dissolution rate of salt in water, stir it
with a spoon.
C
You can put about 4.4 Pounds of softening
salt into the salt reservoir.
5. Replace the lid and tighten it when the reservoir is full.
C
You need to add salt right before starting the
machine. Thus, the overflowing salty water
will be flushed immediately, preventing the
risk of corrosion in machine. In cases where
you would not start washing immediately, run
your machine empty in the shortest program.
C
Since different salt brands in the market have
different particle sizes and since the water
hardness may vary, dissolution of the salt in
water may take a couple of hours. Therefore,
Salt Indicator remains on for a while after
adding salt into the machine.

10. CARE AND MAINTENANCE

A
WARNING:Before cleaning or carrying
out maintenance, switch off the appliance,
disconnect the power supply and turn off the
water tap.
A
WARNING:Do not repair or replace any part
of the dishwasher or attempt any servicing
unless specifically recommended by this
manual. We recommend that the dishwasher
only be repaired by an authorized service
agent.
A
CAUTION :To avoid the possibility of slipping,
keep the floor around the dishwasher clean
and dry.
Keep your appliance free from the
accumulation of combustible materials, such
as lint, rags, and chemicals.
If the dishwasher is not in use for an extended
period of time, we recommend you check that
the baskets are empty, leave the inside of the
dishwasher clean, the door cracked open to
allow air to circulate, turn off both the power
and water supply to the dishwasher.
24
USA

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents