IMPORTANT – Please Read and Follow • Make sure that incoming voltage is the same as Your safety and the safety of others is unit rating. An electric rating plate specifying very important. voltage, frequency, wattage, amperage, and We have provided many important safety phase is attached to the product.
Page 4
• The required use of a GFI is normally related to the location of a receptacle with respect to any significant sources of water or moisture. • Viking Range, LLC will NOT warranty any problems resulting from GFI outlets which are not installed properly or do not meet the requirements below.
Page 5
WARNING WARNING ELECTRICAL SHOCK TIP OVER HAZARD HAZARD Appliance is top heavy Disconnect power or turn and tips easily when not power disconnect switch to completely installed. Keep OFF position before removing top grille. doors closed until appliance Failure to do so can result in death or is completely installed and secured per electric shock.
Dimensions 30” All Refrigerator/Freezer 3 – 1 9 / 3 2 ” ( 9 . 1 c m 36” All Refrigerator/Freezer 3 – 1 9 / 3 2 ” ( 9 . 1 c m i e s v a r r e ) e n t a r d...
Specifications 30” All Refrigerator/Freezer Description FDFB/CFDFB FDRB/CFDRB Overall width 30” (76.2 cm) Overall height (from bottom) 82-3/4” (210.2 cm) min. to 84-1/16” (213.5 cm) max. Overall depth (from rear) To front edge of side trim: 23-3/16” (58.9 cm) To front edge of door trim: 24” (61.0 cm) Cutout width 30”...
Anti-Tip Dimensions 30” All Refrigerator/Freezer Anti-Tip Location 7 9 - 3 ” / 8 ” 1 - 1 / 2 ( 2 0 1 . 6 c m ( 3 . 8 c ) m i n t o b o t t o m a n t i - t i p b...
Anti-Tip Dimensions 36” All Refrigerator/Freezer Anti-Tip Location 7 9 - 3 ” / 8 ” 1 - 1 / 2 ( 2 0 1 . 6 c m ( 3 . 8 c ) m i n t o b o t t o m a n t i - t i p b...
Anti-Tip Dimensions Dual 30” All Refrigerator/Freezer Anti-Tip Location 7 9 - 3 / 8 ” ( 2 0 1 . 6 c m ) m i n t o b o t t o m a n t i - t i p b o a r d 8 0 - 1...
Anti-Tip Dimensions Dual 30” & 36” All Refrigerator/Freezer Anti-Tip Location 7 9 - 3 / 8 ” ( 2 0 1 . 6 c m ) m i n t o b o t t o m a n t i - t i p b o a r d 8 0 - 1...
Anti-Tip Dimensions Dual 36” All Refrigerator/Freezer Anti-Tip Location 7 9 - 3 / 8 ” ( 2 0 1 . 6 c m ) m i n t o b o t t o m a n t i - t i p b o a r d ”...
Cabinet Information Custom panel models, (with 3/4” [1.9 cm], thick panels and custom handles locally supplied), fit flush in 25” (63.5 cm) deep (countertop depth) cabinet openings with no protrusion into room except custom handles Top View Wall 1/4” (.63 cm) space if 25”...
Page 29
Cabinet Information Custom panel models can be installed in standard 24” (61.0 cm) deep openings. However, the door faces and top ventilation grille will protrude 3/4” (1.9 cm) into the room. This is ideal for alignment with full overlay cabinet doors. Top View Flush mount cabinet doors Wall...
Custom Panel General Information Custom finishing options • Panel thickness must not exceed 1” (2.5 cm) • All installations must allow for the refrigerator on hinge side. Thicker panels will interfere with and freezer door to open a minimum of 90˚. door swing and clearance.
Custom Door Panel Installation Remove handle side cabinet screws Remove all screws from handle side door trim. and trim with a phillips screwdriver. Remove two screws from top and bottom door trim. Remove handle side door trim. 2-1/16” 2-1/16” 1-11/16” 1-11/16”...
Page 33
Custom Door Panel Installation Slide custom wood panel to the hinge side, ensuring Reinstall handle side door trim “Z” bracket engages the door bracket. and door trim screws. Reinstall cabinet trim and screws.
Custom Grille Installation Remove air grille center blade. Remove two 1/4” (0.6 cm) screws with a magnetic extended screwdriver at least 8” (20.3 cm) long. Pull air grille assembly forward. Remove 2 mounting brackets from the grille air assembly. Using eight screws removed from the mounting brackets, Insert custom air grille assembly.
Page 35
Custom Grille Installation (cont.) Install two 1/4” (0.6 cm) screws with a magnetic Install custom air grille center blade. extended screwdriver at least 8” (20.3 cm) long.
General Information Area Requirements A 115 volt, 60-Hz, 15 amp, fused, electrical Verify the following: supply is required. It is required that a separate • Unit can fit into residence and can be moved circuit serving only this appliance be provided. around corners and through doorways.
Page 37
This must be considered when checking the • Viking Range, LLC is not responsible for water pressure coming into the unit. property damage due to improper installation or water connection.
General Information Tip Over Hazard • Most of the unit’s weight is at the top. Extra care is needed when moving the unit to Appliance is top heavy and tips easily when not prevent tipping. completely installed. Keep doors closed until appliance is completely installed and secured per •...
Installation Place unit in front of cutout. Pull the center grille louver up at an angle and pull out. Using an 8” magnetic nut driver, Remove grille assembly. remove the two 1/4” screws. Hinge Adjustment Front of unit Loosen the four hinge screws. Adjust door. Remove four side screws and remove unit top.
Page 40
Wall 2 x 4 Refrigerator Attach one 2 x 4 to wall stud (refer to dimensions page Replace unit top and four side screws. for exact location). Wall 2 x 4 Refrigerator If needed, depending on cabinet and depth, Plug in power cord to verify operation. Note: Make sure power switch and attach second 2 x 4 to first 2 x 4.
Page 41
Flush water line by running two quarts of water Pull supply tubing forward under unit. into a bucket. Turn water off Note: DO NOT use plastic water lines. Connect supply tube to water valve using Turn on water supply and check for leaks. a 1/2”...
Verify that drain pan is installed and aligned. Kickplate Installation Align holes on both ends of louvered panels Using a phillips screwdriver, attach the and insert screws. kickplate to the unit and adjust to desired height. Door Stop Adjustment 120˚ 110˚...
Final Installation Replace top air grille. Using an 8” magnetic nut driver, replace the two 1/4” screws. Replace the center grille louver. Open door. The display should flash. Press “ACTIVATE CONTROLS” pad and close door. Note: There is a 6 minute delay before the unit starts.
Performance Checklist Align/square door(s). Verify cabinet size. Verify drain pan is properly installed and Verify electrical supply and water supply there are no leaks on water connection. (if applicable). Install kickplate. Install anti-tip device(s) and verify unit is secure. Remove internal packaging and labels and wipe unit down.
Verify Operations Control Panels All Refrigerator FREEZER REFRIGERATOR MAX FRZ MAX REF DOOR OPEN ACTIVATE FAST ALARM DISPLAY HIGHER LOWER CONTROLS TEMP COOL FAST COOL POWER SAB SHOW HIGH TEMP All Freezer FREEZER REFRIGERATOR MAX FRZ MAX REF DOOR OPEN ACTIVATE FAST ALARM...
• Name of dealer from whom purchased Clearly describe the problem that you are having. If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking Range, LLC at 1-888-(845- 4641), or write to:...
Page 48
Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-(845-4641) or visit our web site at vikingrange.com in the US or brigade.ca in Canada F21344B EN (031515)