Cancelling The Program; Salt Indicator ( ); Rinse Aid Indicator ( ); End Of Program - Viking Range 5 SERIES Use & Care Manual

6.7 CANCELLING THE PROGRAM

Open the door of the product press and hold the Program
Selection / Program Cancel keys for 3 seconds. After the
3 - 2 - 1 countdown, 0:01 is displayed, close the door of
the product and wait for the draining process complete.
Draining is completed in 2 minutes and the machine gives
an audible warning when it is completed.
C
There might be residues of detergent or rinse
aid in the machine and/or on the pieces being
washed depending on the step the program
you have cancelled was in.

6.8 SALT INDICATOR ( )

(SELECT MODELS)
Please check the salt indicator on the display to see
whether there is adequate amount of softening salt in the
dishwasher or not. You need to refill the salt reservoir with
salt whenever salt indicator appears on the display of your
machine.
C
Adjusting the water hardness level is explained
in Water Softening System section.

6.9 RINSE AID INDICATOR ( )

Please check the rinse aid indicator on the display to
see whether there is adequate amount of rinse aid in the
dishwasher or not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator appears on the
display of your machine.

6.10 END OF PROGRAM

Adjusting the amount of rinse aid
1. After switching on your machine, press the Menu key
for 1 second.
2. Using <- and +> keys, proceed to "P:" on the display.
3. Set to the appropriate level with the Selection key.
4. Press the Menu key to exit the settings menu. Your
setting will be saved automatically.
No rinse aid dispensed in P:0 wash position.
1 dose of rinse aid is dispensed in P:1 position.
2 doses of rinse aid are dispensed in P:2 position.
3 doses of rinse aid are dispensed in P:3 position.
4 doses of rinse aid are dispensed in P:4 position.
C
When the program you have selected
comes to an end, an audible warning signal
will warn you to turn off your machine. This
audible signal will warn you with certain
intervals before it turns off.
End of Program indicator will light up when the washing
program is over.
1. Open the door of the machine.
2. Press On/Off key to turn off your machine.
3. Close the door.
C
For energy saving, the machine is
automatically turned off following the
completion of the program or if the program
is not started.
C
Leave your dishes in the machine for about
15 minutes to allow them cool down after
they are washed. Your dishes will dry in a
shorter time if you leave the door of your
machine ajar during this period. This process
will increase the drying effectiveness of your
machine.

6.11 WATER CUT-OFF WARNING

If main water supply is cut or water inlet valve is turned
off the machine cannot take water in and E:02 icon will
flash on the program indicator. As long as the problem
continues, washing program is paused and the water inlet
is checked regularly by the machine; when the water is
restored E:02 icon will disappear after a while and the
washing program resumes.

6.12 OVERFLOWING WARNING

If the machine intakes too much water or there is leakage
at any of the components then the machine will detect this
and E:01 icon will flash on the Program indicator. As long
as the overflowing continues safety measures will become
active and try to discharge the water. If overflowing stops
and safety is assured, E:01 icon will disappear. If E:01
does not disappear, there is a permanent fault. In this case
the authorized service should be contacted.

7. DETERGENT

You can use powder, liquid/gel or tablet detergents in the
machine.
A
Only use in the machine the detergents
produced particularly for use with
dishwashers. We recommend you not to
use detergents that contain chlorine and
phosphate as they are harmful for the
environment.

7.1 ADDING DETERGENT

C
Pay attention to the warnings on the
detergent packaging to get better washing
and drying results. Contact the manufacturer
of the detergent for further questions.
A
Do not put solvents into the detergent
dispenser. There is the risk of explosion!
Put the detergent into the detergent dispenser just before
operating the machine as illustrated below.
1. Push the latch to right to open the detergent dispenser
lid (A).
2. Put suggested amount of powder, liquid/gel or tablet
detergent in the reservoir.
21
USA