Incoming and outgoing RS485 cable shield wires should be connected together, but must not be connected to the Btu meter. 11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • sales@onicon.com System-10-MOD Network Interface Installation Guide 08/16 - 0653-13 / 18321...
System-10 using the procedure outlined in the table on the next page. 11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • sales@onicon.com System-10-MOD Network Interface Installation Guide 08/16 - 0653-13 / 18321...
255.255.255.0 and should not be changed unless necessary. 11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • sales@onicon.com System-10-MOD Network Interface Installation Guide 08/16 - 0653-13 / 18321...
Page 15
Enter the new IP address as shown below and press enter. The following message will appear. 11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • sales@onicon.com System-10-MOD Network Interface Installation Guide 08/16 - 0653-13 / 18321...
System-10 BTU Meter. There are no engineering units associated with these registers. 11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • sales@onicon.com System-10-MOD Network Interface Installation Guide 08/16 - 0653-13 / 18321...
Page 27
Changing the engineering units or multipliers at the Btu meter will affect the rollover point. Contact ONICON technical service prior to making any changes. 11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • sales@onicon.com System-10-MOD Network Interface Installation Guide 08/16 - 0653-13 / 18321...
Need help?
Do you have a question about the System-10 and is the answer not in the manual?
Questions and answers