Barco NIO 5MP System Manual page 85

Troubleshooting
desktop onto this monitor" checkbox, but do NOT
click the "Apply" button at this time.
If you installed your BarcoMed Nio drivers in
SingleView mode (default for Windows 2000) there
will be one rectangle for the virtual display
representing the two heads controlled by each
BarcoMed Nio display controller.
If you installed your BarcoMed Nio drivers in
DualView mode (default for Windows XP) there will
be a rectangle representing each head controlled by
each BarcoMed Nio display controller. This will be
true even if you have only one display connected to
your BarcoMed Nio controller. Both displays of a
display controller cannot be enabled at the same
time unless their display properties match. If
necessary detach the second display of the
BarcoMed Nio Display Controller you are working
with by right clicking on the rectangle that represents
it, deselect "Attached" and click the "Apply" button.
Tip: Since Windows 2000 and Windows XP will not let
you detach the primary display connected to a
particular controller, you may need to temporarily
make another display the primary display.
Caution: If you have a single display configuration
and you have enabled DualView, Windows will not
allow you to attach the second head. This is normal
and not a bug.
4. For the display which is still attached click on the
"Advanced" Button.
5. Select the "Adapter" tab and then click on the "List
All Modes." button. Select the resolution and refresh
System manual Nio 5MP 85