Quantech 3070TSE Manual page 30

FORM QTC3-EG6 (1118)
Unit Dimensions (Cont'd)
221 [8.7] OR 288.0 [11.34]
DIMENTION VARIES BASED
ON CHILLER SELECTED
2242.0 [88.27]
FRAME WIDTH
2255.7 [88.81]
OVERALL WIDTH
NOTE:
Placement on a level surface of free of obstructions (including snow, for winter operation) or air circulation ensures rated performance, reli-
able operation, and ease of maintenance. Site restrictions may compromise minimum clearances indicated below, resulting in unpredictable
airflow patterns and possible diminished performance. The unit controls will optimize operation without nuisance high-pressure safety cut-
outs; however, the system designer must consider potential performance degradation. Access to the unit control center assumes the unit is
no higher than on spring isolators. Recommended minimum clearances: Side to wall – 6'; rear to wall – 6'; control panel to end wall – 4'0'';
top – no obstructions allowed; distance between adjacent units – 10'. No more than one adjacent wall may be higher than the unit.
30
QTC3125TSE, QTC3140TSE, QTC3129THE
(OPTIONAL HEAT
RECOVERY UNIT)
588.3 [23.16]
1473.2 [58.00]
194.6 [7.66]
1753.2 [69.03]
3" VICTAULIC OUTLET
3" VICTAULIC INLET
15.9 [0.63]
MOUNTING
HOLES TYPE
1518.6 [59.79]
1917.9 [75.51]
885.9 [34.88]
WATER CONNECTIONS
4731.4 [186.28]
FRAME LENGTH
4768.9 [187.75]
OVERALL LENGTH
035-24059-010 REV-D
POWER ENTRY
330.2 [13.00] WIDE X 177.8 [7.00] HIGH
1177.0 [46.35]
CONTROL PANEL BOTTOM DETAIL
4" VICTAULIC
INLET
4" VICTAULIC
OUTLET
36.4 [1.43]
MOUNTING
HOLES TYPE
136.8 [5.38]
QUANTECH
36.4 [1.43]
MOUNTING
HOLES TYPE
LD26941