Inspections & Adjustments - Grizzly G0806 Owner's Manual

7. Press the OFF button (see Figure 33),
the green motor light will go out, and the
bandsaw will stop.
ON
Button
OFF
Button
Variable-
Speed
Handwheel
Figure 33. Location of door limit switches (doors
shown fully open for clarity).
8. Make sure the blade has fully stopped, open
the upper and lower wheel doors a few inch-
es, then turn the bandsaw ON.
— If the bandsaw does not start, the upper
and lower wheel door limit switches (see
Figure 33) are working correctly; continue
to the next step.
— If the bandsaw starts, immediately turn the
machine OFF and disconnect power. The
upper and lower wheel door limit switches
are not working correctly. This safety fea-
ture must work properly before proceeding
with regular operations. Call Tech Support
for help.
9. Close the upper and lower wheel doors.
10. Turn the work lamp and the welding lamp ON
and OFF.
11. Turn the grinder ON and OFF.
Congratulations! You have completed the
setup and test run procedures. The bandsaw
is now ready for operations.
Model G0806/G0807 (Mfd. Since 12/15)
Limit
Switches
Inspections &
Adjustments
The following list of adjustments were performed
at the factory before your machine was shipped:
• Blade Tracking ...............................Page 23
• Blade Guide Adjustment .............Page 25
• V-Belt Adjustment ........................ Page 45
Table Calibration .......................... Page 50
•
Guide Post Alignment ...................Page 51
•
Be aware that machine components can shift dur-
ing the shipping process. Pay careful attention to
these adjustments as you test run your machine.
If you find that the adjustments are not set accord-
ing to the procedures in this manual or they do not
suit your personal preferences, re-adjust them.
-29-