Grizzly G0806 Owner's Manual page 29

5. Move the blade guide bracket in or out from
the guide post until the blade guides are
approximately ⁄ " (0.063") behind the teeth
1
16
gullets (see Figure 30), then retighten the
blade guide bracket cap screw.
/ "
1
16
Figure 30. Blade guide positioned approximately
⁄ " behind tooth gullets.
1
16
6.
Loosen the blade guide support cap screws
(see Figure 31).
Blade Guide
Bracket
0.004"
Figure 31. Example of blade guides adjusted
0.004" away from the blade sides.
Model G0806/G0807 (Mfd. Since 12/15)
Blade
Guide
Blade
Guide
Blade Guide
Support
Cap Screw
Blade
7. Place the feeler gauge between the blade
guide and the blade.
Note: If you use the dollar bill, fold it in half
and place it over the blade, as shown in
Figure 32.
Blade Guide
Support
Cap Screws
Figure 32. Using a dollar bill to set blade guide
spacing.
8.
Adjust the blade guide to lightly pinch the
feeler gauge or dollar bill between each guide
and blade side, then retighten the blade
guide support cap screws.
Note: When retightening right blade guard
support cap screw, make sure air hose noz-
zle remains positioned out of blade path.
9. Re-install the blade guard.
Note: Ensure the blade guard does not con-
tact upper wheel or blade.
-27-