Screen Map - ECD TC80 Instruction Manual

S M
CREEN AP
Auto
Standardize
CAL
(Calibration)
Manual
Temp
XMTR
CONFIG
(Configuration)
Sensor
Load Default
DAMP or MORE
OFFSET (DC80 only)
INFO XMTR
(Information)
Sensor
System
SIM
Relays
(Simulate)
4-20 mA
Cal 1 (Offset) using Calibration Solution
Cal 2 (Slope) using Calibration Solution
Enter Grab Sample Determined Value
Enter Offset, the PV value and associated mV
Enter Slope, mV/pH, mV/decade, mV/ppm...
Enter measured Temperature
Set Up
LCD Graph
Label
4-20 mA
(1 or 2)
Output
RELAY
HOLD
Address
Serial Baud rate
Format
Menu
CAL
Password
CNFG
SIM
Type
Sensor 1 or 2 T COMP
ISO PT
Qty of Sensors Choose 1 sensor or 2 sensors
COMP Dissociation, Interference, Percentage, OFF
Sensor/Transmitter Yes/No
Enter Signal Dampening (# of readings to
average, 0-100)
Enter Offset value
Configuration, Serial #, Name, Outputs
Calibration logs, Serial #, Name
Fixed value
Sensor 1 or 2
Ramp
#1 ON/OFF
#2 ON/OFF
#3 ON/OFF
4-20 mA Ch 1 Enter Value
4-20 mA Ch 2 Enter Value
Temp. Format °C or °F
Contrast Adj. 0-100%
Back Light Enter ON time
Range Lock Choose: Auto, ppb, ppm, ppT
Line Screen Duration
Gauge
Bar
TAG ID Enter Name
TAG ON/OFF
POP UP ON/OFF
SENSOR Enter Name
Range (PV or 4 mA =
Temp.) 20 mA =
Trim 4.00 mA
More → CAL
Trim 20.00 mA
3.5 mA
More → Fault 22 mA
NONE
Alarm
Relay 1 Timed
Fault
Alarm
Relay 2 Timed
Fault
Alarm
Relay 3 Timed
Fault
Time out: None, 15 min, 30 min...
Off/On " _ _ _ _ "
Off/On " _ _ _ _ "
Off/On " _ _ _ _ "
Off/On " _ _ _ _ "
Choose Type: pH, Cond, ORP.....
Enter % Comp
Enter mV value
Set Point
Period, Duration
Set Point
Period, Duration
Set Point
Period, Duration
2