Fluke MicroMapper Pro Instruction Sheet page 9

To test a cable:
1 Select the cable type in setup.
2 Connect the cable to the tester. The tester shows
when a cable is not connected.
3 Connect a remote identifier to the far end of the cable (optional).
4 Press T.
5 Wire numbers with a fault flash on the display. The EF icons appear if
information is available for additional faults. Use D or C to see the
other faults.
Tables 1, 2, and 3 show examples of cable test results.
Table 1. Test Results for Good Cable
Pass (PASS) results for unshielded, twisted pair
cable.
Remote ID #1 detected.
Pass results for unshielded, twisted pair cable.
No remote ID detected.
no CAbLE
(no cable)