Changing The Length Units; Setting Up The Tester - Fluke MicroMapper Pro Instruction Sheet

Changing the Length Units

1 Turn off the tester.
2 Hold down L; then hold down O until the display shows
(length unit).
3 Press D or C to select a length unit (m or ft).
4 Press A to save the setting.

Setting Up the Tester

To change items in the setup menu (listed below), press S; then do the
following:
•
To change an item, press D or C; then press A to save your selection.
•
To scroll past an item without changing it, press A.
•
To exit setup mode, press S. The tester shows
indicate the setup changes were made successfully. Press T, L, or
W to run a test.
Cable Types
The selected cable type is displayed briefly when you run a test. For twisted
pair cable, the wire size is also shown.
•
CoA CAbLE
: coaxial cable
: RG-6 coaxial cable, 75 Ω
r9-6
: RG-6 coaxial cable, 75 Ω, with a user-defined length calibration
r9-6USEr
parameter
r9-58 : RG-58 coaxial cable, 50 Ω
You cannot turn off the tester in setup mode.
Note
SEt PASS
LEn Unit
(setup pass) to