Maintenance - Fluke MicroMapper Pro Instruction Sheet

Maintenance

To avoid possible fire, electric shock, personal injury, or damage
to the tester do not open the case. No user-serviceable parts are
inside.
Cleaning
Clean the display with glass cleaner and a soft, lint-free cloth. Clean the case
with a soft cloth dampened with water or water and a mild soap.
To avoid damaging the display or the case, do not use solvents
or abrasive cleansers.
Replacing the Batteries
See "Battery Installation and Status".
Restoring Factory Defaults
To restore the user-defined length calibration parameters and other settings
to the factory defaults, do the following:
1 Turn off the tester.
2 Hold down T and D; then press O and wait until the display shows
rESEt
(reset) before releasing the T and D keys.
3 Press C to select
W
Warning
W
Caution
yES
(yes); then press A.
X