Fluke MicroMapper Pro Instruction Sheet page 6

Battery Installation and Status
To avoid possible electric shock or personal injury:
•
Turn off the tester and disconnect all cables before installing the
batteries.
•
Use only the correct type of batteries, properly installed in the
case, to power the tester and probe.
Installing Batteries in the Tester
1 Remove the battery door screw under the bail on the back of the tester.
2 Install the 6 AAA alkaline batteries, noting the polarity shown in the
battery compartment.
3 Replace the battery door and secure it with the screw.
The tester's batteries last for about 100 hours of typical use. Replace the
batteries when the low battery indicator (
Installing Batteries in the Optional P
1 Remove the middle screw on the back of the probe.
2 Remove the battery door.
3 Connect the 9 V alkaline battery and place it in the battery compartment,
taking care not to pinch the battery wires.
Replace the probe's batteries when the probe's volume weakens or the
probe stops working.
W
Warning
3000 Probe
RO
X
) appears.