Testing Cables - Fluke MicroMapper Pro Instruction Sheet

: RG-58 coaxial cable, 50 Ω, with a user-defined length
r9-58USEr
calibration parameter
•
FtP CAbLE
: shielded twisted pair cable
•
UtP CAbLE
: unshielded twisted pair cable
CAt5
: Category 5 cable
CAt5-USEr
: Category 5 cable, with a user-defined length calibration
parameter. Shows as
Wire Sizes
A-28 A-26 A-24
, ,
Calibration Mode
•
CAL yES
(calibration: yes): Enter length calibration mode. See
"Calibrating Length Measurements".
•
CAL no
(calibration: no): Do not enter length calibration mode.
Beeper
•
bEEP yES
•
bEEP no
: (beeper: no) Beeper is off.

Testing Cables

The cable test checks for wiring faults based on the wire map stored for the
selected cable type and measures the cable length.
A remote identifier is not required for the cable test; however, opens at the
far end and miswires are not detected without a remote identifier.
CAt5 UA
-
A-22
,
: (beeper: yes) Beeper is on.
-<wire size> when you run a test.