Assembly - Husqvarna R135 Workshop Manual

2
14
Electrical system
Dismantle the ignition module and the
centrifugal clutch.
502 50 18-01
Remove the nut holding the fl ywheel.
502 51 49-01
Remove the fl ywheel.
502 51 49-01
Remove the remaining screws (A)
holding the ignition module and both
screws (B) that hold the centrifugal
clutch.
Lift off the clutch, both support washers
and the ignition module.
Remove the nut holding the fl ywheel.
Fit the puller on the fl ywheel. Loosen
and remove the nut.
Dismantle the fl ywheel from the crank-
case using the puller
no. 502 51 49-01.
Gently knock the puller screw with a
hammer, if the fl ywheel sits tightly on the
crankshaft.

Assembly

Check that the cast key in the fl ywheel
and key way in the crankshaft are unda-
maged.
Fit the fl ywheel and centrifugal clutch.
Do not forget the washers (A).
Note the slots on the washer lie closest
to the fl ywheel. Align with the equivalent
pins on the fl ywheel.
NOTE!
The completely fl at side on the
clutch should rest against the
washer closest to the fl ywheel.