Husqvarna R135 Workshop Manual page 40

333/335
(mod. L och RJ)
503 80 17-01
Centrifugal clutch
Check the inside diameter of the clutch
drum. If it exceeds 64.0 mm it should be
replaced.
The shaft contains a long guide for the
drive axle.
Dismantling for possible replacement is
done by fi rst removing the plastic sleeve
(B).
336
Check the clutch drum for wear.
The diameter must not exceed 64.0
mm. If this is the case replace the clutch
drum.
The drive axle is guided in the shaft
with the help of a star shaped guide (A)
which the axle runs through. This pre-
vents axle oscillation, which in turn can
cause vibration.
The axle and guide can easily be pulled
out of the shaft once the sleeve (B) is
pried off with a screwdriver.
Model 333/335
On models with a two-piece shaft, the
guide becomes accessible once the
shaft has been split (see chapter 3).
Dismantle the sleeve (A) and pull out
the guide (B) by pulling the drive axle.
Model 336
Loosen the turn handle (A) and both
screws (B). Press down the locking
spring (C) and seperate the shaft.
Pull out the drive axle (D) and remove
the sleeve (E) with the help of a screw-
driver. This makes the guide for the
drive axle (F) accessible if it must be
replaced.
Assembly
333/335
Assemble in the reverse order as set out
for dismantling.
Check that the circlips are fi tted correctly
in respective slots.
Lubricate the hole (A) in the clutch
drum's connection on the drive axle
using copper paste to aid assembly and
dismantling in the future.
Rub the vibration element (B) with talc so
that it slides into position easier.
Lubricate the drive axle with grease no.
503 80 17-01 when assembling in the
guide.
4
39