Husqvarna R135 Workshop Manual page 26

Fuel system
Assembling the carburettor
Blow the carburettor housing clean.
Fit a new plug.
Fit a new main jet.
Remove the valves and dampers. If
336
these components are worn, idling is
disrupted.
Note how the choke valve (1), the throt-
tle valve (2), the recoil springs (3) and
(4) and the lever arm (notched by the
arrow) (5) are fi tted.
NOTE!
Do not lose the ball and spring in
the carburettor housing where the
choke shaft is stored.
Always replace the valves and dampers
at the same time.
Assembling the carburettor
• Blow all channels in the carburettor
compartment clean
• Mount a new plug.
Use a suitable punch to get a com-
pletely tight seal.
• Press in a new main jet.
3
25