Husqvarna R135 Workshop Manual page 14

E
E
E
F
G
Electrical system
Option A
Loosen the screw and slide the cable
holder (B) forwards.
Remove the screws and slide the cover
(D) forwards.
Remove the 3 screws (E) and swing the
engine body to one side.
333/335
Dismantle the short-circuit cable from
the ignition module.
Option A
Loosen the screw (A) and slide the ca-
ble holder (B) forwards on the shaft.
Remove the screws (C) and slide the
cover (D) forwards on the shaft.
Remove the 3 screws (E) and swing the
engine body to one side.
Option B
Lift out the ignition lead and short-circuit
cables from their guides.
Remove the 3 screws (E) and swing the
engine body to one side so the clutch
becomes accessible.
336
Dismantle the short-circuit cable from
the ignition module by removing the
screw (F) and prying off the fl at pin con-
nector (G).
2
13