Husqvarna R135 Workshop Manual page 25

3
24
Fuel system
Dismantle the main jet (A) and the plug
(B).
333/335
Press out the main jet (A) with a suitable
punch.
Remove the plug (B).
Carefully drill a small hole (Ø 2 mm)
in the plug and pry it up with a pointed
object.
Remove the valves and dampers. If
these components are worn, idling is
disrupted.
Always replace the valves and dampers
at the same time.
NOTE!
Do not lose the ball and spring in
the carburettor housing where the
choke shaft is stored.
Note how valves and recoil springs are
fi tted.