Husqvarna R135 Workshop Manual page 12

Electrical system
Still no spark?
Check the ignition cable's connection to
the spark plug cover.
Use pliers no. 502 50 06-01 to make a
hole in the ignition lead.
502 50 06-01
Attach the ignition coil to the ignition
cable.
When there is still no ignition spark,
dismantle the short-circuit cable from the
stop switch.
Remove the connector by prying it up
out of the throttle with a knife.
Still no spark?
Check the short-circuit cable with the
help of an Ohmmeter.
Also see "Dismantling" below.
Still no spark?
Check the spark plug connection.
Remove the spark plug cover and make
sure the ignition cable is not damaged.
Remove a segment of cable if required
to get suffi cient contact at the connec-
tion coil.
When a part of the ignition lead has
been cut off it helps to use the pliers no.
502 50 06-01 to make a hole in the igni-
tion lead to fi t the contact coil.
NOTE!
It is important that the tip of the
contact coil hits the centre of the
ignition lead to prevent sparking.
Attach the ignition coil to the ignition
cable and ensure that the wire is folded
along the cable.
Slide the contact coil into the spark plug
cover.
TIP!
Lubricate the hole in the spark plug
cover so that it is easier to slide in the
contact coil.
2
11