Allen-Bradley PanelView Plus 400 Installation Instructions Manual page 20

20 PanelView Plus and PanelView Plus Compact 400 and 600 Terminals
Connect AC Power
WARNING
ATTENTION
Follow these steps to connect AC power.
1. Disconnect power from the terminal.
2. Secure the AC power wires to the terminal block screws.
3. Secure the protective earth ground wire to the protective earth ground terminal screw
on the input terminal block.
L1
L2/Neutral
4. Apply AC power to the terminal.
Publication 2711P-IN002G-EN-P - November 2009
Explosion Hazard - Do not disconnect equipment unless power has been switched off and
area is known to be nonhazardous.
Disconnect all power before installing or replacing components. Failure to disconnect
power may result in electrical shock and/or damage to the terminal.
Improper wiring of power terminals may result in voltage at the communication
connector shells. Refer to the following figure when wiring.
Do not apply power to the terminal until all wiring connections have been made. Failure
to do so may result in electrical shock.
Protective Earth
to Ground Bus