Allen-Bradley PanelView Plus 400 Installation Instructions Manual page 18

18 PanelView Plus and PanelView Plus Compact 400 and 600 Terminals
Connect DC Power
WARNING
Follow these steps to connect DC power.
1. Disconnect power to the terminal.
2. Secure the DC power wires to the terminal block screws.
Follow the markings on terminal blocks and terminal for proper connections.
3. Secure the functional earth ground wire to the functional earth ground terminal screw
on the input power terminal block.
DC+
4. Apply 24V DC power to the terminal.
Publication 2711P-IN002G-EN-P - November 2009
Explosion Hazard - Do not disconnect equipment unless power has been switched off and
area is known to be nonhazardous.
Disconnect all power before installing or replacing components. Failure to disconnect
power may result in electrical shock and/or damage to the terminal.
Functional
DC-
Earth Ground
to Ground Bus