Cisco Ata 191 Analog Telephone Adapter Administration Guide For Cisco Unified Communications Manager - Cisco ATA 191 Administration Manual

Product-Specific Configuration Parameters
Parameter
HTTPS Server
Admin Password*
SSH Access
Cisco Discovery Protocol (CDP)
Link Layer Discovery Protocol (LLDP)
LLDP Asset ID
Log Server
IPv6 Log Server
Remote Log

Cisco ATA 191 Analog Telephone Adapter Administration Guide for Cisco Unified Communications Manager

32
Description
Enable both HTTPS and HTTP connections to the ATA 191, or
restrict connections to HTTPS only.
Default: HTTPS and HTTP
Set the password to access the Web Administrator interface.
The password can be from 8 to 127 characters.
Set whether the ATA 191 accepts SSH connections. If you block
SSH connections, then access to the ATA 191 is blocked.
Default: Disabled
Enable or disable the CDP function of the ATA 191.
Default: Enabled
Enable or disable LLDP on the ATA 191.
Default: Enabled
Set the Asset ID from LLDP. The maximum length is 32.
If using IPv4, specify an IP address and port of a remote system
where log messages are sent.
If using IPv6, specify an IP address and port of a remote system
where log messages are sent.
Specify where to send the log data by serviceability. If enabled,
log data is copied to the location specified by the Log Server or
IPv6 Log Server parameters. If disabled, log data is not copied
to the log server location.
Default: Disabled
Configure the ATA 191